1. When cleaning the rubber conveyor belt, first turn off the steam valve and adjust the pressure according to the position of the tensioning device.

2、对机电设备，用塑料包起来。

2. For mechanical and electrical equipment, it should be wrapped in plastic.

3、将橡胶输送带连接，把清洗机接220v交流电。

3. Connect the rubber conveyor belt and connect the cleaning machine to 220 V AC.

4、对橡胶输送带进行浸湿。

4. Wet the rubber conveyor belt.

5、将清洗溶液与水的比例以1:10融合，搅拌均匀。

5. Mix the cleaning solution and water in the ratio of 1:10 and stir evenly.

6、用冲枪将清洗溶液均匀的喷洒在大带上，注意大带的加强边，不要用用过大的冲力，以免伤害大带，冲枪要一次性扫过，不要重复冲洗。

6. Spray the cleaning solution evenly on the belt with the flushing gun. Pay attention to the reinforcing edge of the belt. Do not use too much impulse to avoid damaging the belt. The flushing gun should be swept once and do not wash repeatedly.

7、用清水冲洗，这个时候要仔细，因为一般橡胶输送带很难清洗干净，所以大家得格外注意，认真清洗，再把它烘干。

7. Wash with clean water, this time to be careful, because the general rubber conveyor belt is difficult to clean, so we have to pay special attention to, carefully clean, and then dry it.

以上的精彩内容来自：山东输送带批发详细的内容请点击进入我们的网站进行查询对接：https://www.huafengxiangsu.com

The above wonderful content comes from: Shandong conveyor belt wholesale. For details, please click to enter our website for query and docking: https://www.huafengxiangsu.com