In the application of conveyor belt in the whole production process, necessary scratches and damages are inevitable. In the whole production process, repair and repair must be used. Conveyor maintenance belt is a common cold vulcanized rubber bonded and repaired in the whole production process. In the whole production process, the appearance and size of the repair belt must be appropriate according to the size of the damaged part. Under the belt conveyor belt manufacturers and everyone in-depth analysis of the characteristics of the conveyor belt repair.

　　条输送带修复通常可以分为通用恢复和修复的文章,文章普遍只修复层的抗压强度和耐磨性的硫化橡胶层与强力胶半硫化橡胶硫化橡胶粘合剂层的特异性,主要用于胶带硫化橡胶的表面损伤破坏,保持胶带芯层织物层或镀锌钢丝绳的侵蚀和破坏;在硫化橡胶层,厚修复层织物层,层织物提升有很大提高抗压强度在文章的结构修复胶粘剂渗透破坏,划定磨损和冷胶头密封经常有良好的修复效果,抗压强度必须固定汇率水平的织物结构,应用程序必须考虑所有的正常工作。

　　Generally, the repair of conveyor belt can be divided into general recovery and repair articles. In this article, only the compressive strength and wear resistance of the repair layer are generally specific to the vulcanized rubber layer and the semi vulcanized rubber adhesive layer of the strong rubber, which are mainly used for the surface damage and damage of the vulcanized rubber of the belt, to maintain the erosion and damage of the fabric layer or the galvanized steel wire rope of the belt core layer; in the vulcanized rubber layer, the thick repair layer Fabric layer, layer fabric lifting has greatly improved the compressive strength in the article's structural repair adhesive penetration damage, delimitation of wear and cold rubber head sealing often has good repair effect, the compressive strength must be fixed to the exchange rate level of fabric structure, the application program must consider all normal work.

　　输送带修复胶粘剂必须注意到应用程序条损害,往往是硫化橡胶损坏或常刮刮和眼泪太多,选择相对论应该修理,不要使用一般修理修理胶带撕裂,和表面损伤的硫化橡胶条厚修理修理带是完全没有必要的,但必须增加细抛光1的深度,促进建设劳动。

　　The adhesive for repairing conveyor belt must pay attention to the damage of application program strip, which is usually the damage of vulcanized rubber or too much scraping and tears. It is not necessary to use the general repair tape for tearing, and the thick repair belt for surface damage vulcanized rubber strip is completely unnecessary, but the depth of fine polishing 1 must be increased to promote construction labor.

　　条输送带修复回层翡翠硫化橡胶作为特异性层,这一半硫化橡胶层是修复胶粘剂表面刷,刷后冷硫化橡胶胶TX,硫化橡胶层可以用强力胶在常温条件下迅速产生硫化橡胶反映,产生胶效果类似于热硫化橡胶、胶粘剂与热硫化橡胶抗压强度可以超过同行。半硫化橡胶作为特殊层的存在，使胶布的冷胶修补更有效、更容易操作、更牢固。

　　Emerald vulcanized rubber is used as the special layer for repairing conveyor belt. The half of the vulcanized rubber layer is the surface brush of repairing adhesive. After brushing, the cold vulcanized rubber TX is used. The vulcanized rubber layer can quickly produce vulcanized rubber under normal temperature with strong rubber. The rubber effect is similar to that of hot vulcanized rubber. The compressive strength of adhesive and hot vulcanized rubber can exceed that of the same industry. Semi vulcanized rubber, as a special layer, makes the cold rubber mending of the rubber cloth more effective, easier to operate and stronger.