0531-83510047
19863682868

大家都在搜: 食品级输送带 大倾角输送带 切菜机输送带

当前位置: 首页 - 新闻中心 > 公司新闻 > 公司新闻

使用输送带时必须注意这几点!

来源:http://www.huafengxiangsu.com 时间:2020-03-13 15:35:05 浏览次数:
输送带是带式输送机的关键运输部件,是承载原材料运输的关键。的利弊的质量部分传送带传送带熊在机械设备的应用现状,和传送带上占有重要比例的带式输送机,大倾角带式输送机输送带约占三分之一的成本,因此选择合适的输送带输送机械设备成为机械设备设计需要一定要考虑的因素。接下来,bo ao输送机来讨论一下输送带。
Conveyor belt is the key transport component of belt conveyor and the key to carry raw material transport. The advantages and disadvantages of the quality part of the conveyor belt bear in the mechanical equipment application status, and the conveyor belt occupies an important proportion of the belt conveyor, the large angle belt conveyor conveyor belt accounts for about one third of the cost, so the selection of appropriate conveyor belt conveyor mechanical equipment has become a mechanical equipment design need to consider factors. Next, Bo Ao conveyor to discuss the conveyor belt.
在带式输送机中使用输送带时必须注意以下几点:
The following points must be paid attention to when using the conveyor belt in the belt conveyor:
带式输送机在输送原料时,必须充分考虑所输送原料的相对密度、大粒径分布、油品或化学品等特性。原料不含在一定程度的腐蚀或酸碱度下,这样会危害带式输送机部件的输送带寿命。也像原材料的比例,粒度分布是大的,小的片或粉末颗粒等,在设计带式输送机时,这都是必须考虑的。
When conveying raw materials, the belt conveyor must fully consider the relative density, large particle size distribution, oil or chemicals and other characteristics of the conveyed raw materials. Raw materials are not contained in a certain degree of corrosion or pH, which will endanger the life of the belt conveyor components. Also like the proportion of raw materials, particle size distribution is large, small pieces or powder particles, etc., which must be considered in the design of belt conveyor.
大倾角输送带
带式输送机运输路线布置;沿着向一头带式输送机,尾巴中间的辊筒间距,如带式输送机根据客户要求必须执行情况,如一个角落还必须考虑在拐角处传送带位置可能在采矿业进行应用,许多远程移动带式输送机基础上必须提升,转移可能会发生,所以输送机配件时还必须考虑输送带的强度对拉。
The transportation route of belt conveyor is arranged; the distance between rollers in the middle of tail and one end of belt conveyor, for example, the belt conveyor must be implemented according to the customer's requirements, for example, a corner must also consider that the conveyor belt position at the corner may be applied in the mining industry, many long-distance mobile belt conveyors must be lifted on the basis of which the transfer may occur, Therefore, the strength of the conveyor belt must also be considered when the conveyor accessories are pulled.
带式输送机的承载能力是运输能力、网络带宽和带速的总和。一般运输皮带所能承受的张力是比较有限的,如果原材料的比例比较大,而运输皮带又不能承受运输机械设备操作所需要的张力,就很容易造成运输皮带的断裂。此时输送带的选择可以考虑采用含有镀锌钢丝绳芯的双层输送带。带式输送机的连接头也与带式输送机的运行有关。如果目前输送带的绝大部分两边都是用裁平的输送带在两端对准,那么用螺丝来拧紧,也可以有效的其他封头方法
The carrying capacity of belt conveyor is the sum of transportation capacity, network bandwidth and belt speed. Generally, the tension that the transportation belt can bear is relatively limited. If the proportion of raw materials is relatively large, and the transportation belt can not bear the tension required by the operation of transportation machinery and equipment, it is easy to cause the fracture of the transportation belt. At this time, the selection of conveyor belt can consider the use of double-layer conveyor belt with galvanized steel wire rope core. The connection head of the belt conveyor is also related to the operation of the belt conveyor. If at present, most of the two sides of the conveyor belt are aligned with the cut conveyor belt at both ends, then the screw can also be used to tighten other effective head methods

产品中心 PRODUCT CENTER

联系我们CONTACT US

手机:13791000079(孙经理)
座机:0531-83510047
QQ(客服):136559297
地址:山东省济南市章丘区刁镇民营经济开发区